XtraView lets a second or third decoder run on the same DStv subscription instead of paying a separate fee for each room. It is not just a matter of plugging in another decoder. The dish needs the correct LNB, each decoder needs its own feed, and the units have to be linked with a heartbeat cable so the account sees them as one installation.

We set the whole thing up and test it. Most of the XtraView faults we are called to in Rondebosch are half finished jobs where somebody ran a splitter off a single cable instead of feeding each decoder properly, and the second room works until both decoders want a different transponder at the same time.

  • Correct LNB fitted so each decoder gets its own feed
  • Separate cable run to every decoder position
  • Heartbeat cable connected between the linked decoders
  • Link registered so all rooms sit on one subscription
  • Every room tested and channel changed independently
Two DStv decoders linked with a heartbeat cable for XtraView

How we do it

Extra View / XtraView Setup in Rondebosch, done properly

Cabling a second room in an older house

The older established homes in Rondebosch were never wired for multiple decoders, and many are double storey, so the second feed usually needs a new run. We plan it through the roof space, along existing trunking or up an outside wall with a drip loop and a sealed penetration, rather than drilling the shortest line through the middle of your lounge wall. Where a run is genuinely impossible we say so before we start.

Why a splitter is not the answer

A splitter shares one feed, so two decoders end up fighting over the same band and you lose channels when somebody changes the channel elsewhere in the house. The correct answer is an LNB with enough outputs, or a multiswitch where there are several decoders. We fit the right part instead of the cheap one, because a splitter fault looks like a weather problem and gets misdiagnosed for months.

Adding a third decoder or a complex setup

Three decoders, a dish shared with a cottage, or a flat in a Rondebosch complex with a communal system all change the design. We look at the whole installation, count the feeds needed, and work out whether a multiswitch is the sensible route. On a complex we check what the body corporate allows and connect to the communal system where there already is one.

Common questions

Extra View / XtraView Setup in Rondebosch: your questions answered

Does XtraView mean I pay twice?

No. That is the point of it. The linked decoders sit on one subscription with a single access fee for the extra decoders, rather than a full separate subscription per room. The saving only holds if the link is registered correctly, which is part of what we set up on the day.

Why does my second decoder lose channels when somebody changes the channel?

That is the classic sign of a splitter where a proper feed is needed. Both decoders are sharing one cable and one band, so they cannot tune independently. Fitting the correct LNB and running a dedicated cable to each decoder fixes it permanently rather than hiding it.

Can I link an Explora and an older decoder?

Yes, in most combinations, with the Explora as the primary unit. The pairing rules depend on the models, so we confirm what you have before the visit. We then fit the heartbeat cable, register the link and test both rooms independently before we pack up.

Do you have to run a new cable?

Usually, unless there is already a spare coax to the second room. Many Rondebosch houses have one cable from the dish and nothing else. We would rather run a clean new feed than split the existing one, and we plan the route so the cable stays out of sight.

Ready to book

Book extra view / XtraView setup in Rondebosch

We work Monday to Saturday across Rondebosch and the suburbs around it, with emergency callouts when a business is down.